Exocet

Before we turbo our Exocet, we need to improve our fuel flow rate by upgrading to more powerful fuel injectors. We decided on a set of Flow Force 640cc Fuel Injectors which should

A good upgrade to the stock ignition system for a Miata-based engine is to upgrade to a Coil-on-Plug ignition system. We chose to install the Denso Ignition Coil-on-Plugs which should give us a

We new nothing about engine tuning before we installed the MegaSquirt MS3Pro PnP and we were expecting we would need to learn and experiment a lot before the Exocet would run well. For

We decided early on we would eventually go forced induction and one of the first steps before doing so is to upgrade to an aftermarket standalone ECU. The MegaSquirt ECU is among the

We were getting worried about our radiator as it was getting little dents in the fins with all the high velocity rocks flying into it. To add a level of protection, we decided

After each track day, we’ve noticed that the engine would develop a pretty loud ticking noise. We would flush the engine, rebuild the 96’ Miata’s Hydraulic Lifters, and replace the oil with Mobile

We had started the whole California DMV process to register the Exocet for road use back in May but it took until now to finally get all the paperwork through.

The previous RAZO foot pedals we installed were a source of endless frustrations as they were way too large for the cramped footwell of the Exocet.

One of the improvements we’ve been meaning to make is to close up the hole below the windshield. The windshield that we had installed floated in the middle of the cockpit and does

On our first track day, we felt the Exocet had a lot of body roll while turning aggressively which isn’t a surprise since we are still using OEM shocks and springs.